Classic Design AC Design  DC Design Solar Design CS Docs and Links

Colloidal Silver DC Generator III - LW's new and improved Design
by Lightman - revised 11.16.03

As each year goes by improvements in the process of making colloidal silver abound.
The Colloidal Silver Generator III reflects these improvements over the Colloidal Silver Generator II.

The improvements Include:

Making the Colloidal Silver Generator III

Supplies You will need to make this new colloidal silver design:


- a DV adapter (9V/ 300mA-500mA). Available at Radio Shack for about $5. I got several for .25 cents each at a thrift shop.
- distilled water
- 1/2 quart mason jar
- two 99.99% pure silver wires , coins, or bars
- aquarium air pump (often found at thrift shops)
- two insulated alligator clips, from Radio Shack
- small wooden base (4" x 8" or so)
- saw or Swiss army knife for cutting wood strips
- wood glue for jar top
- electric drill and bit
- plastic lid (as a base for Mason jar)
- large rubber band or elastic cord (to secure DC adapter to base
- wood scraps to make jar cap/wire holder

Additional supplies

- Surge protector strip with on/off switch. So you can turn on DC .adapter and air pump at the same time.
- Funnel to transfer the silver elixir into storage bottles
- scotchbrite pad for cleaning silver wires after each use

 

 


Making the Generator
1. Cut wooden base to fit DC adapter, and Mason jar.
2. Cut wooden cross bar that fits top of Mason jar (1" wider than jar mouth)
3. Drill two holes one inch apart in the center of cross bar (to hold silver wires). These should be just slightly larger than diameter of silver wires.
4. Glue two small wooden pieces to opposite ends of wooden cross bar, so bar fits snugly onto top of Mason jar. (you can turn jar upside down on top of the cross bar to glue the ends so the fit will be exact).
Note: To use silver bars or coins instead of silver wire electrodes, this design must be modified. I suggest permanantly attaching the alligator clips to the side of the wooden crossbar, with the clips pointed down (1/2" below bottom of the crossbar). In this way you can attach any silver coin or bar to the alligator clips.
5. With the adapter unplugged :-) cut the DC adapter plug (cut the low voltage wire end, not the wall plug end) and leave most of the wire attached.
6. Strip about 1/2 inch off of each of the cut wire ends.
7. Attach alligator clips to the wire ends and crimp with pliers, or solder to secure them.
8. Install safety switch and/or a small light bulb* to wire between alligator clips and the AC adapter (not shown in photos, as I use a surge protector with a built in switch and light).
9. Assemble generator as shown in the photo below. Make sure that the air pump is rubber banded to the base, or it will vibrate off. :

10. Fill mason jar with distilled water 1/4" to 1/2" from the top.
11. Attach the 2 alligator clips to silver wires ends sticking up from the cross bar, and slip them through the drilled holes in the jar's wooden cross bar.
12. Plug in the AC adapter to wall outlet. You are ready to begin making colloidal silver solution.
13. Throw switch on the surge protector while muttering "It's alive... it's alive" like Doctor Frankenstein.
14. Set a timer for three to four hours minutes.
15. Make sure that both the pump and the DC adapter are working. You can hear the pump, but might have to test the DC output with a voltage tester.
16. The bubbler enhances the quality of the silver solution and reduces white scale and black silver crystals (which you don't want in the final product). Tiny fizzy bubbles will start to form after a few minutes on one pole. A flashlight beam helps to see this.
17. After process is completed, strain mixture through a non-bleached coffee filter or cotton cloth to remove any crystals or scale. Store the elixir in a dark glass bottle in a cool place. This is reported to keep for several months, but it is best to make small quantities as needed. Fresh is best.
18. Wash mason jar, and air pump tube after every use, then rinse with distilled water. Clean silver wires with scotchbrite pad to remove scale and silver crystals, then rinse. Dry then store all components of the generator together in a dust-proof tupper or container.


The Generator III hooked up to surge protector.

Dosage
The usual dosage is 1-2 tablespoons twice per day. Some people with touchy stomachs claim that their intestinal flora can be disrupted by colloidal silver. I haven't had a problem with this myself. But if this happens to you, it is best to swish it around the mouth and/or gargle the solution and not swallow. This allows absorption of beneficial silver ions through the mucus membranes (sublingual absorption). Eating yogurt several hours later will replace any friendly bacteria lost.

Alternative health sources "claim" that colloidal silver offers some protection from air or water-born viruses and pathogens (such as the common cold, flu, smallpox, anthrax, S.A.R.S., etc.) and recommend increasing dosage to one to two ounces, twice per day when danger or symptoms appear. These sources state that one must take the solution for 5-7 days before full protection to take effect.

*An online reader suggested that a small light bulb be added in-line as a safely feature, to show when contact is being accidentally made.




Canadian Maple Leaf coins - from any coin seller
two one-ounce bars of 99.99% pure silver click here
the best source I have found for 99.99% thick pure silver wire - click here

Warnings/ AMA disclaimer

This device is meant to produce colloidal silver solution, which is a nutritional supplement. We make no claims ourselves concerning the medicinal use of Colloidal Silver Solution as an antibiotic or as a curative agent (The A.M.A. takes a dim view of anyone interfering with their pharmaceutical profit margins).

Some individuals report disruption of friendly flora within the digestive track after ingesting colloidal silver. For those who are gastricly sensitive, handbooks recommend gargling with the solution like mouthwash without swallowing. This is reported to protect friendly intestinal bacteria while gaining the reported benefits of colloidal silver ions. (utilizing sublingual absorbsion - whereby many silver ions are absorbed through mucus membranes of the mouth). Others use an atomizer to inhale colloidal silver mist.

High dosages of colloidal silver ingested over an extended period of time are not recommended, as these (according to A.M.A. reports) can cause the buildup of silver residue in the joints, gums and eye whites. With millions of Americans now using colloidal silver on a regular basis, we wonder why we are not seeing blue-gray people walking around, which the AMA assures us is a side-effect. (Independent researchers have actually ingested thousands of times the recommended dosage over an extended time and have not observed any of the AMA's reported side-effects).

When we consider the dreadful toxicity of pharmaceutical antibiotics, colloidal silver's side effects, if any, are minor by comparison.

Live long and prosper!
Lightman

Classic Design AC Design  DC Design Solar Design CS Docs and Links

comments or suggestions? lightman@lightwatcher.com
Return to Lightwatcher's Colloidal Silver Webpage